1.25" LIGER GUN BELT

LGB12534B
  • 1.25" LIGER GUN BELT

1.25" LIGER GUN BELT

LGB12534B

Description

1.25" Liger Gun Belt
*** Reading and following the 
sizing instructions are required before placing an order.
  About the Liger™ Gun Belt
The Liger Gun Belt represents a major break-through in gun belt design, utilizing custom components and proprietary processes developed by and available exclusively from Maxpedition.

Made in USA.
Biothane™ Belt Material

The Biothane belt material is a 21st century composite developed by Maxpedition. Thanks to its high-strength resin-embedded polyester fabric core, Biothane possesses over 2,000 lbs of tensile strength with over 300 lbs of hole pull strength. The highly abrasion-resistant polyurethane coating makes the belt totally impervious to salt water, blood, mildew, mold, rot and resistant to many common solvents. 
 

Biothane is flexible along its length for comfort yet
 stiff along its width so you can carry holsters, sheaths, or pouches without the belt sagging or twisting. Biothane has a super grip interior so the belt and any belt holstered items stay put while the patterned exterior imparts a supple, organic appearance. 
 

The Liger Gun Belt is tough enough to wear with your BDU's but attractive enough for dress slacks making it ideal for discreet CCW. Best of all, Biothane is easy-to-clean - just rinse with mild detergent and wipe dry.

 
Biothane™ Leather Nylon
Resists mildew Yes No No
Resists bacteria Yes No No
Waterproof Yes No No
Remain soft & flexible to –20F Yes No No
Cleans in seconds Yes No No
Maintenance free Yes No Yes
Leather look & feel Yes Yes No
Will not fray Yes Yes No
Consistent tensile strength Yes No No

 

Liger Buckle & Construction  
The Liger Gun Belt buckle is painstakingly machined from a solid billet of T6-6061 aircraft aluminum with our exclusive integral hook design. In other words, the hook is part of the same piece of material as the buckle (NOT plugged or glued in, NOT brazed or welded on).  


After a two-step finishing process, Type-III hard-anodized finish (MILSPEC-A-8625) is applied for incredible wear resistance. The Liger buckle and Biothane belt are riveted together using robust 3/16" stainless steel rivets resulting in a strong, permanent one-piece construction.

 

Liger Gun Belt sizing is based on ACTUAL WAIST CIRCUMFERENCE in inches. Each belt is handmade one at a time upon receipt of order based on the sizing information you provide. In order to prevent ordering an incorrect size and to insure a tailored fit, please carefully read the following simple measuring instructions:

1. Do NOT order according to your pants size. Please measure your waist circumference in inches with a cloth tailor's tape (or a measuring tape).


2. Put the tape through the loops on your pants as you would usually wear them, measuring all the way around your waist with any equipment you wear on your belt or inside your waist band like guns, knives, phones, pouches, etc.


3. This waist circumference measurement is your belt size and should be the location of your primary hole. If you measure an odd number (ex: 41 inches), order the next higher even number size (Size 42).


4. Each belt comes with six (6) pre-punched holes. Besides your primary hole, we provide two additional holes going smaller and three additional holes going larger at one (1") inch increments for fine adjustment.


5. Each belt is custom built to order and components are permanently rivetted together, consuming the components and rendering them impossible to reuse. 


6. For belt sizing inquiries, please call 310-768-0098 or to place an order, call 1-877-629-5556.